"Samson after much research I settled on BH EE-Pro 2 with the 16 premium keg
Rick will have 2-1"" Fpt ( female pipe thread fittings) welded , one on the bottom
and one off-set and at a different elevation . I also added 22"" long ferrells
One bottom front for drain and one half way up past shoulder for fill up and drain. I also
asked Rick to weld a short 3 inch Ferrell at top. At first ill use the bung
but later ill do as BYUE sp did with a thermometer cap .
I'm well below the grand you spoke of. Rick is the greatest
guy to deal with and he is very accomidating and accessible
But be aware you will probably have to wait bearing your soul
in patience but all good things come to those who wait
If I was not 100% certain I would not refer them the #
is on page bottom left Rick will call you back but it may take awhile
and if you don't hear from him in a day or so call back
in the end you will be glad you went with them.
Wayne in California where the nuts come from"

Hi Samson,
I would suggest you contact Rick. He may have a supplier north of the border. I would suggest the 15 gallon boiler as most who have the 8 wish they got the 15. It is a lot cheaper to do it now rather than let regret have you buy it later. Whwn I do full runs I just use to 25l bucket for fermentation. You are correct a full 15g kettle is very heavy. Mine sits on a movers dollly for mobility and I use a pump to drain it. Good luck, Maddawgs