 Rank: Junior Member Groups: Registered
Joined: 10/22/2007(UTC)
Posts: 21
|
"Hi...2 quick questions,, Just recieved the PS II extractor and started to assemble it... I was left with 1 Keg O-Ring....do I need this ring cause I cant see where it would go... 2) I have the copper mesh packing and if I use the reflux method....do I pack the upper and lower columns or just the bottom?? ...thanks  "
|
|
|
|
|
|
 Rank: Senior Member Groups: Registered
Joined: 10/22/2005(UTC)
Posts: 817
|
" Originally Posted by: firefly263  Hi...2 quick questions,, Just recieved the PS II extractor and started to assemble it... I was left with 1 Keg O-Ring....do I need this ring cause I cant see where it would go... 2) I have the copper mesh packing and if I use the reflux method....do I pack the upper and lower columns or just the bottom?? ...thanks The O ring is for when you get a sanke keg, and then to connect to it. Pack the whole column, and then stuff some small balls of copper around the cooling tubes to make them more efficient."
|
|
|
|
|
|
Rank: Junior Member Groups: Registered
Joined: 10/22/2007(UTC)
Posts: 21
|
"ok...so I dont need the o-ring.... and I pack the top and bottom....excellent....many thanks.....much appreciated... "
|
|
|
|
|
|
 Rank: Newbie Groups: Registered
Joined: 4/6/2008(UTC)
Posts: 2
|
the o ring goes between the tower and keg. you want that seal so you don't have blowoff at that joint. nobody likes losing skin.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
