 Rank: Newbie Groups: Registered
Joined: 8/20/2009(UTC)
Posts: 3
|
"I am wondering i fany body knows of any safty
proablems with theese products ? I have OATEY
safe flo silver lead free solder and No.95 leadfree
tinning flux past same stuf used on hot and cold watter
pipes in houses. Would there be any thing wrong with using
them on my stack and condencer
Thanks"
|
|
|
|
|
|
Rank: Newbie Groups: Registered
Joined: 8/25/2009(UTC)
Posts: 3
|
Any lead free solder will be fine.
|
|
|
|
|
|
 Rank: Senior Member Groups: Registered
Joined: 10/22/2005(UTC)
Posts: 817
|
Excellent choices. Go for it.
|
|
|
|
|
|
Rank: Newbie Groups: Registered
Joined: 8/20/2009(UTC)
Posts: 3
|
"Thanks I thought it would proabably be fine one other thing I was wondering about is the left over flux in the fittings and condenser
There isent much because I scrubed it with dish soap and a bottle brush befor I soldered the 45 and the 90 togather so there isnt any big globs or anything but it does seem to have a slight greesey feal to the inside of the stack (1""diameter ) as far as i can reach with a finger anyways
I was thinhing of using som rubbing alchol and a clean brush to try to get anny thing else ,or might this be a wast of time
Thanks agai for all the info"
|
|
|
|
|
|
Rank: Newbie Groups: Registered
Joined: 8/25/2009(UTC)
Posts: 3
|
"Waste of time, you should make several good cleaning runs and maybe even a cheap wine for practice anyway.
Good Luck
J.B."
|
|
|
|
|
|
Rank: Newbie Groups: Registered
Joined: 8/20/2009(UTC)
Posts: 3
|
"cleaning runs ? how manny and what would be safe iv'e ran some pot fulls of watter thriugh without condinsing basicly straight steem would this be enough or should I run a wash or two through it ?
Thanks again for all info"
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
